thread: Cage Question
View Single Post
  #1  
11-17-2015, 10:49 PM
BLUESMAN1970's Avatar
BLUESMAN1970
Member
 
: Sep 2015
: Stapleton AL
: 65
Cage Question

Ok guys we started on the cage in my s10, with the S&W kits the main hoop is designed to be moved forward to miss the rear cab mount. However I didn't know that when we set the main hoop back as far as we could due to me being so tall in an effort to make more room. With that being said as you can see in the picture below we placed it on the raised section of the floor pan on the base plates which would normally be used with a uni-body car. After I thought a little more about it I realized we might have messed up. For starters I don't know if it will certify like this much less protect me in a roll over. My understanding is the main hoop is supposed to be a point of contact to the frame and since it will be a full 10pt cage the two front bars and the down bars into the bed will be connected to the frame will this work?? If not what can I do to fix it??

Thanks in advance,

Howard
Attached Images
 
Reply With Quote